Securecrt check license key3/21/2024 After all the system LEDs flash amber, release the Reset button.Press and hold the Reset button while applying power to the switch.Hi if the switch has solid amber ight, it means that the switch is stuck in boot mode.ġ-Please try to disconnect from the Power outlet the ICX-7150 and reconnect it.Ģ-Please try to press the reset button using a paper click or a small stick I have no networking experience so I hope that someone can help me with the issue I am having. NAND read: device 0 offset 0x4000000, size 0x2000000ġ ecc_errors after reading 58b8000:58b8800Īs I stated above, I cannot provide keyboard input to enter "b" to stop at boot monitor.Īt this point I am unsure what to do or even if I assumed correctly that the config file become corrupted during the power outage. Ĭould not boot from primary, no valid image trying to boot from secondary # Loading kernel from FIT Image at 70000200. NAND read: device 0 offset 0x0, size 0x2000000ħ ecc_errors after reading 18b8000:18b9c00 Ruckus Wireless Bootloader: 10.1.14T225 (04:59:18 -0800)ĭRAM: Validate Shmoo parameters stored in flash. Here is the log that displays when the switch is connected to secureCRT: I have also tried using a USB-C to USB-A cable. I have tried this while using a RJ-45 cable to serial and serial to USB. I have ensured that the settings are configured as Baud 9600, data bits 8, parity none, stop bits 1, and flow control none. ![]() ![]() I attempted to follow this YouTube video ( ) to flash a new image to the switch but I am unable to provide keyboard input while using HyperTerminal or SecureCRT. ![]() After some searching on forums, etc I believe that the boot config file has been corrupted or along those lines. After being unplugged I noticed that my switch was not booting properly and that the light for "system" is a solid amber color.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |